|Message: BooleanProcessor - Too many edges problem||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
I have a problem when I try to visualise my geometry, caused by a Boolean solid from which I have done several subtractions. This was not a problem in v9.2.p01 and only appeared when I upgraded to v9.4.p02.
The viewer window (OGLSX) opens but then the message "BooleanProcessor::createPolyhedron : too many edges" comes up repeatedly (does not seem to stop) and the geometry never appears. The application works fine when not using the viewer.
If I reduce the number of subtractions I get only a few such messages and the geometry appears. Still fewer subtractions result in no messages. There are 10 subtractions in total (9 boxes and one cylinder) and it fails on the eighth.
I have noticed that there seems to be a mention of this in the v9.4 release notes (http://geant4.cern.ch/support/ReleaseNotes4.9.4.html) but it does not say what to do about it.
Any help would be very much appreciated.
|Inline Depth:||Outline Depth:||Add message:|