|Message: Confine command in GPS||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
I recently tried to use the /gps/pos/confine command to create a uniformly distributed source. I received the following error: LoopCount = 100000 Either the source distribution >> confinement or any confining volume may not overlap with the source distribution or any confining volumes may not exist If you have set confine then this will be ignored for this event. even though I knew my source was well contained within the volume. There have been questions in the forum about this error, but no answer was given. The solution to my particular case was to include the /gps/pos/centre command- even though the confinement volume was at 0,0,0 and the default gps center is also at 0,0,0 , this error occurs unless the center is explicitly defined. I assume its just a peculiarity of the code.
|Inline Depth:||Outline Depth:||Add message:|