|Message: Re: unsetting G4UI_USE_XM when using CMake||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
If you want to unset GEANT4_USE_XM after using cmake to setup Geant4 I will do it in the following way:
[Third] Perform any changes to you flags.
[Fourth A] If not changes, quit by pressin 'q'.
[Fourth B] If changes were made, press 'c' for configure. After it configures (it can take few seconds - check the progress bar) then you need to press 'g' for generate (and it will exit ccmake after it is done)
At this point your Geant 4 installation should reflect the changes made. Notice this is way faster than recompiling the whole distribution from scratch.
Now I have to admit in my distribution I did not see G4UI_USE_XM flag when I use ccmake on my system. I don't not how to unset that precise flag. Guessing, I would probably unset it in my main function of my program:
#ifdef G4UI_USE_XM #undef G4UI_USE_XM #endif
Give it a try and see if this helps. Otherwise, I would let the experts answer this question.
|Inline Depth:||Outline Depth:||Add message:|