|Message: Re: segmentation fault after changing geometry||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
I also have the same problem. however only if I run more than one event per geometry update.
My system goes through all geometries successfully if only one event is run.
I also already include the command
is this the command you are refering to regarding the update?
I also tried to use the command (as it was suggest in a previous post)
however this function does not seem to exist in the G4RunManager class. It is not found by the compilier and is commented out in the online source code of the class.
Is this perhaps a cause of problems?
Many thanks for any help
|Inline Depth:||Outline Depth:||Add message:|