|Message: Particles Dont Recognize Parameterized MLC Geometries||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
Thank you so much for your help. Yes, an error is occurred when i was posting reply to you. System sent 3 times at once or i did, i am not sure about that but couldn't erase them. I contacted with admin in order to fix it.
May i ask a question about what is my real problem which is simulation doesn't recognize volumes which placed into same place with each other.
I stacked them one by one at the same certain place cause i need them at the same area of geometry. In order to do this i should have created 4 of "MLC Container" so called Carriage in Varian TrueBeam. As you mentioned before, i tried to see what is wrong with geometry by using "/tracking/verbose". So i realized when i define one volume on another as MLC Container that they have exact match with each other, geometry has created but physics has not been working on volume which has been defined after the first-defined-volume in source file (CC file).
How do i deal with it? If i create all MLCs in my source file of geometry it is like 6000 row of code in my source file of geometry.. So i have been trying parameterization process. Also i attached some of my geometry. If you have time, i would appreciate your help
My best regards,
Attachment: http://hypernews.slac.stanford.edu/HyperNews/geant4/get/AUX/2018/06/06/08.57-34943-MLC_1.png http://hypernews.slac.stanford.edu/HyperNews/geant4/get/AUX/2018/06/06/08.57-49580-MLC_2.png http://hypernews.slac.stanford.edu/HyperNews/geant4/get/AUX/2018/06/06/08.57-5227-MLC_3.png