|Message: Photon Propagation through 2 different material.||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
Dear all Hello, Could you allow me to ask one question? I have a radiator bar which made of fused silica. This is for studying Cherenkov radiation. If I shoot some particle through this radiator, it generates Cherenkov photons. And, of course these photons are propagated inside the radiator bar with internal reflection. (Outside of radiator is vacuum. Some photons are go out when the incident angle is large.) Now I want to add a block of glass on the one side of radiator. This glass has higher refractive index than radiator. So, I though that photon should be propagated through the glass. However, this simulation doesn't finished for 2 whole days. I didn't set reflection & efficiency parameter of glass. I set border surface property between fused silica and glass, the optical surface is as below. optsurface->SetType(dielectric_dielectric); optsurface->SetFinish(polished); opsurface->SetModel(unified); new G4LogicalBorderSurface("rad_glass",radiator,glass,optsurface); I didn't set any other surfaces. What can I do in this case? Should I set more parameters? Thank you so much. Have a nice day.
|Inline Depth:||Outline Depth:||Add message:|