|Message: Re: G4UnionSolid and G4SubtractionSolid causes Error||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
thanks for the fast reply.
I did have a closer look to the standard output, but it is the only error/warning. There is no earlier output:
" /vis/viewer/set/autoRefresh true /vis/viewer/refresh ERROR: G4VSceneHandler::RequestPrimitives Polyhedron not available for link_1. This means it cannot be visualized on most systems. Contact the Visualization Coordinator. "
When I change the first parameter from link_do from 10 to 9.9 everything is running fine: G4Trd* link_do = new G4Trd("link_do",9.9*mm ,5*mm ,5*mm,5*mm, 10*mm);
This may indicate a problem with the surfaces. However, if one changes G4Trd to G4Box everything is working fine. So there seem to be a problem with G4Trd within G4UnionSolid or G4SubtractionSolid.
Does any one have a proposal (except of changing the dimensions), as I would like to keep my geometry as correct as possible.
Thank you very much Cheers Matthias
|Inline Depth:||Outline Depth:||Add message:|