Message: Re: BREP import/export Not Logged In (login)
 Next-in-Thread Next-in-Thread
 Next-in-Forum Next-in-Forum

None Re: BREP import/export 

Forum: Geometry
Re: Question BREP import/export (Dragos Constantin)
Date: 21 Sep, 2010
From: John Apostolakis <John Apostolakis>

Dear Constantin,

The recommended route for importing BREP geometries is to use a STEP 
file and a tool which tesellates the relevant solids, creating a GDML file.

Then the resulting file can be read using the GDML interface.

Best regards,
John Apostolakis

On 8/8/10 6:45 AM, Dragos Constantin wrote:
> *** Discussion title: Geometry
> Dear Colleagues,
> What is the status of BREP interface in Geant4? I might be wrong but
> from what I know in v9.3 there is no example that uses BREP
> import/export features. I intend to look at Geant4 BREP capabilities and
> any experience or advice will be more than welcomed.
> Thank you in advance for your insight into the problem.
> Dragos
> -------------------------------------------------------------
> Visit this GEANT4 at message (to reply or unsubscribe) at:

John Apostolakis
Tel: Office +41-22-767-7239
      Mobile +41-76-242-0801

 Add Message Add Message
to: "Re: BREP import/export"

 Subscribe Subscribe

This site runs SLAC HyperNews version 1.11-slac-98, derived from the original HyperNews

[ Geant 4 Home | Geant 4 HyperNews | Search | Request New Forum | Feedback ]