|Message: Problem running an example in vGate.||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
I AM HAVING PROBLEMS RUNNING AN EXAMPLE IN vGATE.
The Gate installation was saved in the standard vGate working directory using Virtual Box (Ubuntu-64 bit)
The example I want to run is saved in the example1 folder located here.
Suppose I open a command terminal. I want to run example 1 located within the example_Radiotherapy/example1 folder called main.mac
I type Gate main.mac and I receive an error because the directory path to the location is not set.
So, now i set the directory path by writing.
Now, I type Gate main.mac
The example runs but, there is a problem within the main macro which states that it cannot find GateMaterials.db or verbose.mac so, I must set the macroPath within the main.mac for the location of these files.
So, in-front of the verbose.mac, I now set the macroPath as listed below.
/control/macroPath /Progs/Gate/ /control/execute mac/verbose.mac
Now, the problem is solved for the verbose.mac and GateMaterials.db but, the other commands in my main.mac file now have directory problems of there own.
THIS IS MY MAIN PROBLEM. A DIRECTORY PROBLEM FOR RUNNING AN EXAMPLE.
I can try using Gate first to run the example and type Gate then run the main.mac macro file.
Gate runs properly and I now type.
Idle> /control/execute main.mac
I receive an error that says set directory path to main.mac by /control/macroPath .
So, I try to set the macroPath in Gate.
Idle>/control/macroPath /Progs/Gate/gate_v7.2/examples/example_Radiotherapy/example1 /control/execute main.mac
I get no response from Gate
DOES ANYONE KNOW HOW TO GET PAST THIS DIRECTORY PROBLEM? ANY SUGGESTIONS WOULD BE GREATLY APPRECIATED.
Thanks, Kurt Van Delinder
|Inline Depth:||Outline Depth:||Add message:|