|Message: Transportation manager has too many active navigators||Not Logged In (login)|
Click on the Forum title, e.g. on the "Forums by Category" page, to read a sequence of postings to the Forum and its threads all in one page. If you are only interested in one thread or the thread following a specific posting, click the thread or the posting, which takes you to a smaller page, which contains only the part you are interested in and may be easier to navigate.
Messages are "chained" if there are only replies at the first level, i.e. 1/1.html, 1/1/1.html etc. In case of "chained" messages the message number is replaced by the icon and there is no indentation.
Inline: Display the subject line only or also the text of the posting(s); for the choice "All" the "Outline" choices are switched off.
|1||0||1||no text / full text of posting|
|2||1||All||text for level 1 only / text for All postings|
Outline: Choose the depth of the posting thread, successive toggle controls provide increasing detail.
|1||2||1||2 levels / 1 level (original posting)|
|2||3||2||3 levels / 2 levels|
|3||3||All||3 levels / all levels (all postings)|
I created a detector geometry with 30 alternating absorber and scintillator layers (a total of 60).
The width of the absorber layers is different to the width of the scintillator layers, so I had to create a macro which sets up 60 scorers, in turn, one for each layer, then runs an event, then outputs the value for energy deposited (eDep) in each layer, one by one.
However, on running the macro in UI mode, I get the following error:
### Run 0 start. Start Run processing.
---> Begin of event: 0
--------- Ranecu engine status --------- Initial seed (index) = 0 Current couple of seeds = 9876, 54321 ---------------------------------------- ERROR - G4PathFinder::PrepareNewTrack() Too many active Navigators. G4PathFinder fails. Transportation Manager has 9 active navigators. This is more than the number allowed = 8 !
*** G4Exception : TooManyNavigators issued by : G4PathFinder::PrepareNewTrack() Too many active Navigators / worlds *** Fatal Exception *** core dump ***
*** G4Exception: Aborting execution *** Abort trap
Does anyone know how I can get around this? When I run the macro with 3 absorber layers and 3 scintillator layers (6 total), the macro executes fine and I get the desired output. However, any more than this and I get this error.
|Inline Depth:||Outline Depth:||Add message:|