Message: Re: Why does my mesh-name show up as ProcName in output? Not Logged In (login)
 Next-in-Thread Next-in-Thread
 Next-in-Forum Next-in-Forum

None Re: Why does my mesh-name show up as ProcName in output? 

Forum: Biasing and Scoring
Re: Question Why does my mesh-name show up as ProcName in output? (Stefan E. Mueller)
Date: 28 Mar, 2014
From: Tsukasa Aso <Tsukasa Aso>

Hi,

  I am confusing about the matching between the commands and the output of tracking verbose
you showed.

  You are defining thin scorers of dz=0.025 cm and place those at Z=578.445 cm, 652.095 cm, 
and 725.755 cm. However the output of tracking verbose shows Z = 204 mm where is not
in those scoring volume.

  If I believe the output of tracking verbose, the ion might be almost at rest and 
did not move long distance. This is just my guess.

 Best regards,
 Tsukasa Aso

 Add Message Add Message
to: "Re: Why does my mesh-name show up as ProcName in output?"

 Subscribe Subscribe

This site runs SLAC HyperNews version 1.11-slac-98, derived from the original HyperNews